With this enhancement, you can use the Materialise Build Processor installed on your network without depending on a predefined 3D printer list maintained by PTC.
User Interface Location: N/A.
Release: Creo Parametric 9.0.0.0

What is the benefit of this enhancement?
This improvement removes the limitation of waiting for a new Creo release to access updated or newly supported printers. Instead, it allows you to work with a wider range of Build Processors and easily add new 3D printers as needed.

By eliminating reliance on a fixed printer list, this enhancement increases flexibility, accelerates adoption of new hardware, and simplifies the overall 3D printing workflow within Creo.

Additional Information

Tips:None.
Limitations:The following conditions apply to this enhancement:

• It is available with AM+ license.
• It is applicable only to squared printers. Round trays are not supported.
• The BP of some printers does not provide enough data; some printers may require special or reserved licensingand are not supported.
Does this replace existing functionality?No.
Configuration option associated with this functionality:None.

For more information, Follow this link.

Subscribe to this blog for a daily dose of Creo Tips (Add your email address in the subscribe button available at the top of this page).