Tag creo 4.0
This is a post by Aaron Shaw on PTC site. Discusses how moving one profile is easy in Creo Advanced Framework Extension (AFX). But, moving two or more can be tedious…until now. In Creo 4.0, moving multiple profiles in Creo… Continue Reading →
This is a post by Natasha Reaves on the Rand 3D site. Starting in Creo Parametric 4.0, when using an object/action workflow, you can use 2D box selection in combination with the selection filter settings to select only items of the… Continue Reading →
This is a post by Rachel Jones at Concurrent Engineering. The system would not have specified the corner seam definition for the neighbour if you had tried to create the wall in this example in the past, However, when you select… Continue Reading →
This is a post by Rachel Jones at Concurrent Engineering. Typically, seams on a part are created in pairs, with both seams being the same type. Once one seam is set up, simply copy it to the others on your part…. Continue Reading →
This is a Post by Rachel Jones at Concurrent Engineering. Some time ago, PTC introduced the “flexible modeling” extension into Creo. Changes to models and retaining design intent are now easy thanks to the direct modelling capabilities within Flexible modelling in… Continue Reading →
This is a post by Aaron Shaw on PTC. Finally, Creo 4.0 includes geometry-based selection and optimized pre-highlighting. The previous smart selection filter has been replaced by a geometry selection filter, which highlights edges and surfaces by default. Check out… Continue Reading →
This is a Post by Rachel Jones at Concurrent Engineering. It is now possible to change a corner type with just a few clicks. Simply select a corner face, and then select Edit Corner Seam in the mini toolbar (or the Flexible Modeling tab of… Continue Reading →