This is a post by Nate Frazee on the Rand 3D Site.
When modeling a leaf spring, the length of the spring stays constant, while the radius changes size based on the amount of compression. This design intent can be captured in the sketch.
This is a post by Nate Frazee on the Rand 3D Site.
When modeling a leaf spring, the length of the spring stays constant, while the radius changes size based on the amount of compression. This design intent can be captured in the sketch.
© 2023 PTC Creo Tips — Powered by
Theme by Anders Noren — Up ↑
Leave a Reply